
#Scar stock crack forum upgrade#
I would upgrade all the screws in the receiver. Revise the carrier so that there is less reciprocating mass, and is not as vulnerable to cracking under higher operating pressures.ĭevelop a new stock/hinge, its neither durable or idea for precision shooting. Lightweight 13.5 to 16 inch 308/6.5cm barrelsĪdditional Settings for the gas regulator, They did this 50 years ago, with the FAL, Do it again. I would Scrap the Mk17 and refine the Mk20. If I was the put in charge of the FN, I would enact the following changes. I like the platform, and think that it has unrealized potential. I am on the fence if I am going to keep my Scar or not. I never played with the stocks of SCARs in gun. To protect your 1200, you should have that crack checked out.
#Scar stock crack forum cracked#
So, paying 1200 without knowing for sure whether the guitar has a cracked neck or a finish crack is dicey to say the least. And the stock require some force to lock up in firing position. General rule of thumb - a neck/headstock crack/repair decreases the value by about 50 depending on the severity/quality of the crack/repair. They say it felt cheap, especially the plastic locking piece. Everyone seems to complain about the stock. This is where the Ron Burgundy I don't believe you meme comes in,lol. I was reading some older articles and watching older videos about the SCAR (2011 old). Cheap SS scope on it until I get a NF ATACR for her! I def. If someone at FN mistakenly tells you to send the whole rifle, just say thank you, and still just send the removed stock back.

Send in the stock only, you'll have a new one in a week or two. It will be suppressed as well eventually so the 16" barrel will be nicer for that as well. My 16 stock cracked at the latch a couple of years ago. But, it also has a Precision Armament brake on there and the Knights just has the factory muzzle. I brought out the 20 and one my SR-25s and the 20 is actually softer now. It handles way better and I did not change the jets so it smoothed it out.
#Scar stock crack forum driver#
I usually only shoot out to 600 yds lately and have to driver 2 1/2 hrs just to get to a 1000 yd range. Plus, I have many other rifles I can reach out with. Plus with the 20 you get the Gieselle trigger and the better stock. Make sure you fill the crack as best as you can with epoxy. Drill new holes and epoxy them in then turn the stock on its side drill a 3/16 hole cut and epoxy a SS threaded rod just behind the pillar.

The barrel on the 20 is a better, thicker profile and the barrel extension is larger, attaches with more screws and are more accurate. Get aluminum pillars from Brownells which are 9/16 diameter. i do not have epilepsy (my girlfriend does. While they share most of the same parts etc. I recently took stock of my life and decided to be completely sober and I. Most people jump up and down like crazy and say if you cut a 20 barrel you just have a SCAR 17.

careful not to crack the plastic cover) is what will have to happen. I had a SCAR 17 and it did not do much for me personally. I went to remove my stock air breather cover today to prepare myself for the SCAR. I decided to cut my 20 barrel down to 16" and I love it! I sent it off to Dave Wilson and he did great work with a fast turn around time.
